A-04Sealants

Silicone & Joint Sealing

Sealant is the cheapest part of a building envelope and often the first to fail. Choose the right type, size the joint, estimate cartridges and redo joints around tubs, windows and facades so they last.

T-01Schedule

Sealant types at a glance

General traits. Labels state the exact uses, surfaces and whether a primer is needed.

TypeTypical usePaintableSun exposureNotes
SiliconeTubs, showers, sinks, glazingNoGoodSanitary grades contain fungicide; poor bond to old silicone residue
PolyurethaneConcrete joints, facades, floorsUsuallyVaries by gradeTough and flexible; check UV rating outdoors
Hybrid polymer (MS / SMP)Facades, windows, roofing detailsUsuallyGoodBonds to many surfaces, often without primer
Acrylic latexInterior trim and cracks before paintingYesLimitedLow movement; not for wet zones or exterior joints

Use the type the window, tub or facade maker specifies when they name one.

Q-03Take-off

Sealant cartridge estimator

Volume = joint width × depth × length. Add waste for tooling and cut nozzles.

Input

Starting values are placeholders. Replace them with your own measurements and the product data sheet.

Take-off

Joint volume
—ml
With waste
—ml
Width to depth
—

Cartridges needed

—pcs

Many guides suggest a depth around half the width for wider joints; follow the sealant label.

S-05Sequence

Resealing a joint properly

New sealant over old residue is the most common reason a fresh bead fails within months.

  1. 01/08

    Cut out the old bead

    Use a blade or sealant remover; get it all out.

  2. 02/08

    Clean the joint

    Remove residue and soap film with the cleaner the label names.

  3. 03/08

    Let it dry

    Wet joints do not bond. Leave showers unused until dry.

  4. 04/08

    Backer rod in deep joints

    Sets the depth and stops three-sided bonding.

  5. 05/08

    Mask both sides

    Tape gives straight edges and a clean finish.

  6. 06/08

    Prime if required

    Some surfaces need primer for the bond.

  7. 07/08

    Apply and tool

    One continuous bead, tooled in one pass.

  8. 08/08

    Remove tape and cure

    Pull tape while wet; respect the cure time.

F-03Quick check

When a joint needs redoing

Tick what you see on the tub, shower, window or facade joint.

Joint check · 5 items

0 / 5 ticked

clear

Nothing ticked. Check again in six months.

Q-05RFI log

Sealing FAQ

RFI-01Can I put new silicone over old?

Response

It is a common shortcut, but new silicone bonds poorly to old silicone and dirt. Remove the old bead fully for a joint that lasts.

RFI-02Why does silicone go black?

Response

Mould grows in and under sealant in damp rooms. Better ventilation, a sanitary grade with fungicide and replacing affected beads help; bleach rarely reaches mould inside the bead.

RFI-03How deep should a joint be?

Response

Follow the sealant label. For wider joints, guidance often puts the depth at around half the width, set with backer rod.

RFI-04How long before the shower can be used?

Response

Check the label. Many sealants are dry to touch quickly but need a day or more before water contact.